TrindoMaps .

A little further from familiar.

Coordinate converter

Convert coordinates between decimal degrees, degrees minutes seconds, UTM, MGRS, Plus Codes and geohash. Paste any format or pick a point on a globe or map.

How to use the Coordinate converter

The coordinate converter reads decimal degrees, degrees-minutes-seconds, degrees and decimal minutes, UTM, MGRS, full Plus Codes and geohashes, then shows the same location in all of them. It runs entirely in your browser and needs no account.

  1. Paste a coordinate in any supported format, or choose a point on the globe or map.
  2. Read the same location as decimal degrees, DMS, decimal minutes, UTM, MGRS, a Plus Code and a geohash.
  3. Copy the format you need. Drag the pin on the map to update every format at once.

All formats use the WGS 84 datum. Grid references from other datums, such as OSGB36 or NAD27, will place the point wrongly. UTM and MGRS are not defined above 84° N or below 80° S.

Example

The Eiffel Tower at 48.8582, 2.2945 is 48° 51′ 30″ N, 2° 17′ 40″ E, UTM 31U 448252 5411933, MGRS 31U DQ 48251 11932 and the Plus Code 8FW4V75V+7R.

Try this example in the tool

The formats it understands

Decimal degrees (48.8582, 2.2945) and degrees, minutes and seconds (48° 51′ 29.5″ N) are the formats most maps and phones use. Degrees and decimal minutes (48° 51.492′ N) is common in marine and aviation use.

UTM divides the world between 80° S and 84° N into 60 zones, each 6° wide, and gives a position as metres east and north inside a zone. MGRS is a military form of the same grid that adds 100 km square letters. Plus Codes, also called Open Location Codes, turn a location into a short code such as 8FW4V75V+9R, and a geohash encodes it as a string of letters and digits where longer strings are more precise.

Precision and datum

A 10-digit Plus Code identifies a cell of about 14 m by 14 m, and a 9-character geohash a cell of about 5 m by 5 m. When you enter either, the tool uses the centre of the cell. UTM and MGRS are shown to the nearest metre.

Everything here uses WGS 84, the datum of GPS. Grid references from national systems such as OSGB36 or NAD27 use different datums and can place the same numbers tens to hundreds of metres away, so convert them with the right datum before pasting them in.

How text is read

Separate latitude and longitude with a comma or a space. Put a hemisphere letter (N, S, E or W) before or after each value, or use a minus sign for south and west, but not both. UTM needs a zone and band, such as 31U 448252 5411933, and southern-hemisphere bands run from C to M. Short Plus Codes that rely on a nearby town name are not supported; include the full area prefix.

Common questions

Which formats can I type in?

Decimal degrees, degrees-minutes-seconds and degrees with decimal minutes, with or without N, S, E and W; UTM such as 31U 448252 5411933; MGRS; full Plus Codes with their area prefix; and geohashes.

Why does my UTM or MGRS reference land in the wrong place?

The tool assumes WGS 84. National grids on other datums, and references with a wrong zone or band letter, give a different position.

Why is there no UTM near the poles?

The UTM system covers 80° S to 84° N. Beyond those latitudes the polar stereographic grid is used instead, which this tool does not provide.

Related tools

Read the FAQ for more help, or explore all sixteen tools.